Page 1 of 1
XTS 3000 Firmware (MDC)
Posted: Sun Nov 19, 2006 9:27 pm
by compuman81
At what version firmware does MDC Delay of Silence and PTT ID start working at? For the life of me, I can't get it to work with this radio which has R06.10.02.
I have a radio with 5.6 in it, and it does it fine....I can't figure this out.
This couldn't have anything to do with the DSP version, could it?
Posted: Sun Nov 19, 2006 11:44 pm
by jmr061
Can you post the host/dsp and flashcode of both radios.
Jason
Posted: Sun Nov 19, 2006 11:56 pm
by compuman81
In question : 06.10.02 / 06.05.02
Works : 05.60.00 / 08.02.02
Both have Digital DSP
I have many other controllers with lower firmware/dsp that have never had a problem doing it, but I can't see anything else causing the problem.
Even The Astro Sabers with ancient firmware do it Alright.
Posted: Mon Nov 20, 2006 12:00 am
by jmr061
Whats the flash codes.
Jason
Posted: Mon Nov 20, 2006 5:45 am
by compuman81
problem radio has
imbe
h14
868/298 multikey/otar
conventional mode
Posted: Mon Nov 20, 2006 10:00 am
by tvsjr
Firmware mismatch? I don't think DSP8 is supposed to be in an R05.60 radio...
Posted: Mon Nov 20, 2006 10:09 am
by jmr061
I would agree with that, its possible since in the XTS3000 I believe the host and dsp are stored on different boards.
You should get both radios updated to newer stuff.
I dont think this would cause the problem however, but you never know.
Can you provide the flashcode of both radios, not what options it decodes to.
Jason
Posted: Mon Nov 20, 2006 12:44 pm
by The Pager Geek
Host
And or flash. MDC Options as well, missing.