Page 1 of 1
AS3 for Railroad Monitoring
Posted: Mon Nov 20, 2006 9:34 pm
by NSPD
I'm planning to add a few Railroad channels to my new AS3...
Anyone that uses an AS for these purposes know what the best squelch fine-tune setting is?
Posted: Mon Nov 20, 2006 9:44 pm
by bellersley
I just use the default setting, whatever that is. It works fine for most everything, I've not run into a problem what so ever.
Posted: Mon Nov 20, 2006 10:48 pm
by tvsjr
For my radios, the squelch opens around 1. So, it usually gets set to 2. It all depends on the radio and alignment... program some CSQ channels to each level and play around with it.
Posted: Sun Nov 26, 2006 10:44 am
by NSPD
Thanks for the info guys!
Posted: Mon Nov 27, 2006 10:05 pm
by Hightower
Unless I run into problems, I set the squelch to 1 for all channels with PL/DPL. If the channels is carrier squelch, then I opt for a squelch of 2.
Cheers