Page 1 of 1
MT2000 question
Posted: Fri Nov 24, 2006 4:50 am
by emsbuff3240
Do all MT2000s have MDC1200 in them? I know the MTS have to have the proper flash, but how can you tell if an MT is MDC enabled or not?
Also, does the MT2K use the same software as the MTS?
Thanks
Posted: Fri Nov 24, 2006 5:58 am
by MTS2000des
MDC encode is standard fare on MT2000's. They also do QC and GE Star as well. MT2000's use the same DOS MTSX RSS. they are not CPS programmable however.
Posted: Fri Nov 24, 2006 6:22 am
by emsbuff3240
Thanks.
Is DOS RSS still available from /\/\oto with CPS out? If I get CPS, for my MTS, do I have to pay extra for the dos version?
Im new to the software thing.
Posted: Fri Nov 24, 2006 8:47 am
by wavetar
The DOS RSS is included with the CPS package. At least, we've always received it with ours.
Todd
Posted: Fri Nov 24, 2006 8:53 am
by emsbuff3240
awsome thanks all.
You cant do MDC decode or Alias on the MT right? Can a MTS2K with the MDC flash do decode?
thanks again.
Posted: Fri Nov 24, 2006 9:13 am
by wavetar
emsbuff3240 wrote:awsome thanks all.
You cant do MDC decode or Alias on the MT right? Can a MTS2K with the MDC flash do decode?
thanks again.
Correct, the MT2000 will not do it. The MTS2000 with MDC will.
Todd
Posted: Fri Nov 24, 2006 8:53 pm
by AEC
Too bad my MTS2000 has no provision for MDC as it was not included in the flash, just plain PL/DPL/CSQ.
A4 top display......But NO signalling
