Hi All
i an trying to program p110 uhf 2 ch
I am using r07.00.00 rss
never used it before (or any radio software)but when i press
f3 get/save codeplug
then
f2 read data from radio codeplug
i get message
wrong .mdf file
copy .mdf file from original gp300 rss diskcan you tell me why PLEASE
Thanks
p110 help please
Moderator: Queue Moderator
Probably a checksum error in the file on your disk.
Do what it says: copy the original file from the distribution disk to your computer; that should fix it.
When the program reads the codeplug from the radio, it has to make sure the radio is supported. It can't tell that until it finishes reading the codeplug, then it searches for a matching model number. If it can't find one, you either are using the wrong program or have one with a corrupt file.
Bob M.
Do what it says: copy the original file from the distribution disk to your computer; that should fix it.
When the program reads the codeplug from the radio, it has to make sure the radio is supported. It can't tell that until it finishes reading the codeplug, then it searches for a matching model number. If it can't find one, you either are using the wrong program or have one with a corrupt file.
Bob M.
The other possibility, and what I think is most likely...your RSS version is too old. The RSS for the P110 was originally a "combo" that did both the GP300, and the P110. This appears to be what you are using. Later on, it was changed so the P110 had it's own RSS. I think you might have a model that the older "combo" RSS doesn't recognize, so it's telling you to re-install the "mdf" file, as that's where it has it's record of all the model numbers.
No trees were harmed in the posting of this message...however an extraordinarily large number of electrons were horribly inconvenienced.
Welcome to the /\/\achine.
Welcome to the /\/\achine.
p110
i can get into service and set squelch etc and i can run com test ok
am i just setting path wrong? Thanks for all replies
am i just setting path wrong? Thanks for all replies
If you can get into service that means your RIB, and programming cable are in good working condition.
When you go into service mode I don't believe the software checks model numbers in the MDF file, which is why you can service your radio but can't read it. (correct me if I'm wrong guys)
As wavetar said you probably have the old software which will not work on the newer P110 radios.
The version I'm running is designed specifically for the P110, R08.00.04. I'm not sure if this is the newest, but I've never had a problem programming a P110 with it.
When you go into service mode I don't believe the software checks model numbers in the MDF file, which is why you can service your radio but can't read it. (correct me if I'm wrong guys)
As wavetar said you probably have the old software which will not work on the newer P110 radios.
The version I'm running is designed specifically for the P110, R08.00.04. I'm not sure if this is the newest, but I've never had a problem programming a P110 with it.
p110
Hi All
got the codeplug toread and save can you explain how to change frequency Please
Thanks
Bill
got the codeplug toread and save can you explain how to change frequency Please
Thanks
Bill