Page 1 of 1
XTS3000 Backlight Question
Posted: Thu Jan 04, 2007 5:16 pm
by Johnny Galaga
Is there any way to increase the backlight brightness?
Posted: Thu Jan 04, 2007 5:18 pm
by bellersley
Higher voltage battery?
Joking. There's no way to do it through RSS. The only way I can think of is if you're gutsy and replace the individual LED's.
Posted: Thu Jan 04, 2007 5:22 pm
by DES-AJ
Wouldn't blue or orange rock!
Big job though... You got the keypad, display and the rotary selector at the top... Least all of these can be replaced if you have some extra $$$ and screwed it up.
Posted: Thu Jan 04, 2007 9:11 pm
by Johnny Galaga
Do XTS5000's have a brighter backlight then? I think I recall seeing a few photos where they looked much better.
Posted: Thu Jan 04, 2007 9:36 pm
by Hightower
The XTS5000 does have a brighter backlight than the 3K's
3K LED replacement is not a big task, except for the display.
How about the LED's that roll slowly roll through 7 colors. That'd be wild
Posted: Thu Jan 04, 2007 9:53 pm
by alex
The keypads are cheap enough as it is - I think around $20 or so.. it would be worth it to take it to one of the guys that does SMT stuff with the cell phone modding... see how much he'd charge to swap the keypad out for blue LED's...
Posted: Thu Jan 04, 2007 9:58 pm
by MattSR
I looked at it and I thought the display was the easy bit... the keypad should be easy with an SMT soldering iron, though the LED in the top bit could be a pain (I hate removing the knobs to get the flex out - I always screw them up)
So, where can one source the 7 colour LEDs?
Posted: Thu Jan 04, 2007 11:30 pm
by Johnny Galaga
It looks like this dealer has a good selection:
http://www.hebeiltd.com.cn/?p=product