Batboard

I see on this site that there are part numbers for the HT1000 service cable for the accessory connector that can allow you to try to build one . Are there any similar part numbers like that for the EX series (EX500/600) that have all of the pins where you could try building a service cable? Or is the only way to get a speaker mic for the connector and add pins somehow - they look like pogo pins but I'm not sure what would replace them.. How about for the HT1250/750 portables? For the HT1250/750's I see the cable is much less expensive than the EX series one so buying it over making it is a better way perhaps...

the ex600 is the same cable as the ht1250

No it is not.

The EX500 & EX600 use a smaller sized accessory connector. They are the same style, but not the same size.

Yes - looking at both an HT 750 and the EX 500 the style is the same but the EX500's is cmaller. Thanks for the responses......

ok i stand corrected, i just looked at the schematic and they looked the same.