Page 1 of 1
MTS 2000 UHF question
Posted: Thu Feb 15, 2007 5:09 pm
by n0vzc
Hello,
I just got a MTS2000 FlashPort radio and when I programmed it the radio reset and now all it shows on the display is SLFTST and the green LED flashes. Any suggestions oin why it would do this and how to fix it?
Thanks,
Mike
Posted: Thu Feb 15, 2007 5:20 pm
by dxon2m
Low battery? Bad contacts?
Try using a fully charged battery before programming, low battery is known to create all kinds of weird problems.
Posted: Thu Feb 15, 2007 6:37 pm
by High_order1
Dumb, not-knowledgeable opinion....
Sounds like you are locked in a loop, and can't get far enough to generate a FAIL or FL/xx response.
Can you still read from the radio??
-Shawn
Posted: Thu Feb 15, 2007 7:28 pm
by n0vzc
nope,
I can not read the radio.
Posted: Thu Feb 15, 2007 7:50 pm
by n0vzc
Ok, I was able to read the radio but I can not write to it.
Posted: Thu Feb 15, 2007 7:52 pm
by emsbuff3240
have you charged the battery and cleaned the contacts....
the battery is most likely your problem.
Posted: Thu Feb 15, 2007 8:01 pm
by n0vzc
It is working now. All I did was remove the trunk system that was in there that did not exist and kept telling to rss to write to the radio when it finally did it worked.
Thanks everyone!!!
Mike