Page 1 of 1
GTX 900 -- will mic lines on 16-pin get HearClear'd?
Posted: Sun Feb 18, 2007 4:21 pm
by Jonathan KC8RYW
I know on the MaxTrac, the HearClear module is in the front head, and only the front mic gets HearClear'd. How about on the GTX? Can I use the 16 pins and still be HearClear'd on tx?
Posted: Sun Feb 18, 2007 11:27 pm
by AEC
HearClear is RSS set per channel, so it should not matter how you have the Accy. pins arranged, you should have HearClear available on all the frequencies you have this enabled on.
I only use HearClear on 927.500 as all 'our' 33CM systems do not make use of HearClear, sad but true.
Posted: Mon Feb 19, 2007 10:01 am
by Jonathan KC8RYW
OK, I was only asking because the MaxTracs do not do HearClear on the RF or the Logic board. They do it on the board inside the front display with the volume/on-off knob and the mic jack. Only the front mic can be HearClear compressed on transmit, and only the audio after the volume pot is HearClear expanded on recieve. So, 900 MHz MaxTracs get different heads than all the other bands.
I'm glad the GTX does things differently (I don't have a GTX manual so I couldn't check for sure.)
Posted: Sat Apr 07, 2007 12:17 am
by AEC
The biggest pain with the GTX series, is the trouble with the slow attack time for P.L, it just is not up to par with 99% of the other radios.
The P.L decode time lags behind the carrier, which makes reception a pain for those quick keys as well as those who talk the second the mic is keyed; it cuts off at least one ot two syllables before fhe P.L decodes and opens the receiver.
The GTX mobiles and potables missed the boat here, and it's sad too.
Good basic design, but crappy P.L.
All my GTX radios require more than 100 milliseconds to open the receiver, which is slllooooowwww.
Not to mention squelching action with reverse burst is likewise sslllooooww, with a rather loud squelch tail.
Posted: Sat Apr 07, 2007 3:42 am
by Jonathan KC8RYW
Re: GTX 900 -- will mic lines on 16-pin get HearClear'd?
Posted: Sun Oct 14, 2007 11:35 pm
by AEC
With both the Maxtrac and the GTX, neither radio will have HearClear capabilities through the Accy. connector, it's only run through the TX/RX audio on the GTX and from the front panel on the 'Trac as the radio does not have the capacity to handle this 'option' as a stand alone feature, this is why it was added to the front panel, unlike the GTX, which was designed with HearClear in mind from the start.
You could call the 'Trac an 'upgraded' feature set that was added later as an afterthought.....*DOH*
