Page 1 of 1
Moto CDM 1250
Posted: Tue Mar 06, 2007 8:07 pm
by dbfd588
Cdm1250 will TX only on certain channels. Mainly channels that are simplex. Wont hit repeators. Im not sure if its not sending PL or if its staying on the RX frequency and not changing to the TX frequency. Any ideas?
Posted: Tue Mar 06, 2007 9:16 pm
by Rayjk110
Is there a repeater/direct button programmed? If so, try tapping that.
Posted: Wed Mar 07, 2007 10:00 am
by dbfd588
OK. Im sure he has tried that but I might mention it to him
Posted: Wed Mar 07, 2007 11:33 am
by jackhackett
Could also be low output power, if they're testing it with a portable or nearby mobile a little bit of power will work radio to radio simplex, but not hit the repeaters.
Posted: Wed Mar 07, 2007 1:00 pm
by HLA
if you want to email me the codeplug for it i'll look thru it and check it out?
Posted: Wed Mar 07, 2007 7:49 pm
by dbfd588
I dont do that stuff. Its a friend of mine that has the prolem. I kinda think that the TX power is low. What would cause that? Something blown or what?
Posted: Wed Mar 07, 2007 9:10 pm
by jackhackett
Could be something blown, or the antenna could be bad, or even the antenna connector might have come loose... best way to tell what's really going on is to check it with a watt meter, if the power out and the antenna check okay then you'd have to look at the programming to make sure the freqs and PLs are correct.