Batboard

Hi all
I want to know if anyone here knows where I can obtain service info on the motorola RTL 1005A radiation test fixture???also does anyone know where to get the 8 pin plugs and jacks for a minitor IV pager tryed motorola and they do not sell parts for the pager???? Also the part numbers for them would be appricated.

thanks

richb

The user manual which includes service information is still available from Mot. I ordered one just a short time ago, p/n 6881122E97. However, be warned that since the unit is quite old, many replacement parts are not available. For example, I needed one of the BNC panel-mount jacks used to feed RF into the unit, and that particular Mot p/n was NLA so I had to go to another manufacturer to obtain a part that would work(physically). If you need further information, please PM me.

ok
will remember that.
thanks
richb

Al wrote:I needed one of the BNC panel-mount jacks used to feed RF into the unit, and that particular Mot p/n was NLA so I had to go to another manufacturer to obtain a part that would work(physically). If you need further information, please PM me.

Just an FYI. Those radiation test fixtures did require tuning when replacing the connectors. Think of the fixture as an antenna. If it isn't properly tuned, it presents a VSWR to the radiation source. Considering that they were used from low band to 900 MHz, they were a real PITA to set up properly. You might want to contact the Test Equipment Depot (1-800-323-6967) to see if they still do them (but I doubt that they do) and the cost.

Hello

I just read this post and like to know alittle more on the operation.
Im trying to perform tests on Minitor II pagers and real new to this.
thanks
steve