Page 1 of 1
Help with a "Parts" xts3k
Posted: Sat Mar 17, 2007 1:30 am
by TheOCAstro
Ok, I'm sure I have one of those "Nick" radios that numerous post and stickys keep refering to:
Model#: H09RDH9PW&BN
Host: 7.08.00
DSP: 8.02.02
Flash: 591008-4F1E009-9
It does have a serial number in the CPS but no stickers, My problem is it will receive our Digital channels but will not transmit on them, is there anything I can do, possibly hopefully somthing wrong with programming, can I dump this flash and just get the one I need.....anything???
Posted: Sat Mar 17, 2007 3:21 am
by RocketNJ
Most likely needs an alignment, assuming it is programmed correctly.
Bring it to a qualified shop and have them align it.
Posted: Sat Mar 17, 2007 5:55 am
by jmr061
What is the letter in front of the DSP?
Jason
Posted: Mon Mar 19, 2007 4:53 pm
by TheOCAstro
The whole readout of the DSP is: DSPN08.02.02
Posted: Mon Mar 19, 2007 6:04 pm
by MattSR
What is the TX type set to? ASTRO?
Posted: Tue Mar 20, 2007 12:32 am
by TheOCAstro
Yes, it is set to Astro
Posted: Tue Mar 20, 2007 5:48 am
by Pj
Conventional or trunked?
Do you have the right NAC if conventional?
Other than that, I would say that the radio would need to be properly aligned.
Posted: Wed Mar 21, 2007 4:47 pm
by CTAMontrose
yep.. been there done that... anytime an S-rec gets blown in, the radio should be realigned... a teeny bit off and you get wierd things on astro... not just on TX, but RX as well.
find someone with a nice Astro capable service monitor to have that puppy aligned and ill bet she will be right as rain
Posted: Thu Mar 22, 2007 4:03 pm
by TheOCAstro
Well that worked, not sure if your supposed to do it this way but I copied an alignment from a working radio and now this radio works like a charm, again Thanks for all your help.