ht1250ls+

kc2fht · Post by **kc2fht** » Thu Mar 22, 2007 5:22 am

I appologize if this is a stupid queetion, but does the ht1250ls+ suport MDC Signaling? Just purchased 3, and the shop states they do not suport MDC. It is the 16 ch Limited keypad. Thanks

MTS2000des · Post by **MTS2000des** » Thu Mar 22, 2007 6:42 am

the 1250 LS+ we have support MDC, but only on LTR modes (read=no MDC on conventional but MDC on trunking...go figure)

kc2fht · Post by **kc2fht** » Thu Mar 22, 2007 6:48 am

MTS2000des wrote:the 1250 LS+ we have support MDC, but only on LTR modes (read=no MDC on conventional but MDC on trunking...go figure)

Thanks that explains it.

911-EMT · Post by **911-EMT** » Mon Mar 26, 2007 8:35 am

I have programmed a lot of the ht1250-ls and had no problem with mdc on conventional mode, I am not shore about the ht1250-ls+

kc2fht · Post by **kc2fht** » Mon Mar 26, 2007 8:40 am

seems like it is the 16ch limited keypad only. Of cours the ones we ordered. Thanks

Post by **wavetar** » Mon Mar 26, 2007 1:33 pm

Lots of information on the subject in the knowledge base:

http://batboard.batlabs.com/kb.php?mode=article&k=35

Todd