OT: M/A Com Jaguar 700 help

otter9309 · Post by **otter9309** » Mon Mar 26, 2007 1:53 pm

I know this is a little OT, but I am looking for the pin-out for the Jaguar connector. I am wanting to have a RICK cable made to interface to the XTS series.

TIA
Steve

Elroy Jetson · Post by **Elroy Jetson** » Fri Mar 30, 2007 6:39 pm

http://www.hallelectronics.com/getech/tq-lpe.gif

There ya go.

Elroy

otter9309 · Post by **otter9309** » Sat Mar 31, 2007 7:09 am

Thank you sir, and welcome back.

S.

Elroy Jetson · Post by **Elroy Jetson** » Sat Mar 31, 2007 8:51 am

I realize this doesn't tell you the FUNCTION of each and every line, but it's a start. And if I can dig it up, I found a site that hosts many of the ericsson/ge service manuals. (LBIs) I'll give you the link when/if I find it.

Elroy Jetson · Post by **Elroy Jetson** » Sun Apr 01, 2007 3:55 pm

As I said, I'd give you the link when I found it. Here it is.

http://www.repeater-builder.com/ge/lbi-master-list.html

MANY GE radio manuals are listed here.

I BELIEVE that the M-RK shares the same accessory connector and programming cable as the LPE and Jaguar portables. This suggests that if you can find the full pinout for ONE of them in those manuals, you've got the pinout for the others as well.

Elroy

5-sides · Post by **5-sides** » Mon Apr 02, 2007 2:38 am

For a P7100, which should be the same pin-out:

E1--Rx Data
E2--Emer UDC B
E3--12V in Flash
E4--Ext Mic In
E5--Mute Out
E6--UDC Tx B
E7--Sw A+ Out
E8--UDC Sense
E9--UDC Audio
E10-GND
E11-Tx Data In
E12-PTT UDC B

MM101334V1 Rev B,
Feb-04 pg25 fig 6-6

otter9309 · Post by **otter9309** » Mon Apr 02, 2007 4:39 am

Thanks again for all the help.

Steve