Page 1 of 1
?? XTS 3000 and "real" P25/9600bps systems.....
Posted: Sun Apr 01, 2007 1:16 pm
by batdude
is anyone out there familiar with this?
i was "told" that 7.71 rebanding host would function on radios flashed for 9600bps...
this is NOT the case.... FAIL 002 upon channel change.
anyone?
Re: ?? XTS 3000 and "real" P25/9600bps systems...
Posted: Sun Apr 01, 2007 1:22 pm
by Josh
batdude wrote:is anyone out there familiar with this?
i was "told" that 7.71 rebanding host would function on radios flashed for 9600bps...
this is NOT the case.... FAIL 002 upon channel change.
anyone?
Fail 002, now that's a new one by me. Whenever I tried it with non 9600 trunking firmware radio, I got FAIL-001. I guess I should now check out what FAIL 002 means
-Josh
Posted: Sun Apr 01, 2007 2:02 pm
by Pj
Basic Service Manual wrote:FAIL 001 Synthesizer Out-of-Lock a. Reprogram codeplug
b. Send radio to depot
FAIL 002 Selected Mode/Zone Codeplug Checksum
Error
Reprogram codeplug
Posted: Sun Apr 01, 2007 7:06 pm
by Josh
Pj wrote:Basic Service Manual wrote:FAIL 001 Synthesizer Out-of-Lock a. Reprogram codeplug
b. Send radio to depot
FAIL 002 Selected Mode/Zone Codeplug Checksum
Error
Reprogram codeplug
unfortunately, fail 001 and 002 have the same solution of "reprogramming the codeplug".
I guess it's not 9600 capable, eh... or did you try reprogramming the codeplug/using a different S-Rec?
-Josh
Posted: Tue Apr 03, 2007 11:44 am
by RailroadTech
The latest 5.x Firmware I seen is R06.71.00 2Meg VOCON board I wonder what is with that ?? I thought the only VOCON board for the XTS3000 is I Meg.
R07.71.00 supports Astro 3600 Baud only.
...
Posted: Tue Apr 03, 2007 11:52 am
by batdude
2 meg controller?
part number ?
Posted: Mon Apr 09, 2007 2:49 am
by RailroadTech
Just wishfull thinking I guess only one meg vocon boards, but I believe the firmware is correct.