Someone shut off DHCP in the router. Result: I don't know the routers ip. Can't access the web interface using http or Cisco SDM. I can access IOS thru the console port but i am not proficient in IOS using the CLI.
Any help out there?
Cisco 837 Router Help
Moderator: Queue Moderator
-
Batman
- Posts: 973
- Joined: Sun Sep 09, 2001 4:00 pm
- What radios do you own?: JT1000, Spectras, CB-555, 540
Cisco 837 Router Help
Thank You,
Robert
Robert
Make a manual ARP table entry for the router, and assign it an IP address on your same local subnet that the computer currently is on.
Then, you can try and connect remotely to the router, and see if that works. Other than that, just hook up the console cable to the device, kick open a terminal session, and give it some love...
Then, you can try and connect remotely to the router, and see if that works. Other than that, just hook up the console cable to the device, kick open a terminal session, and give it some love...
from IOS 'show ip interface brief" should show the ip addresses of the various interfaces.
-- Welcome My Son, Welcome To The Machine --
Bob Vaughan | techie@tantivy.net
AF6RR | P.O.Box 19792, Stanford, Ca 94309
-- I am Me, I am only Me, And no one else is Me, What could be simpler? --
Bob Vaughan | techie@tantivy.net
AF6RR | P.O.Box 19792, Stanford, Ca 94309
-- I am Me, I am only Me, And no one else is Me, What could be simpler? --
-
spareparts
- Batboard $upporter
- Posts: 502
- Joined: Fri Dec 19, 2003 5:33 pm
Re: Cisco 837 Router Help
Go to the Cisco Website: http://www.cisco.com/en/US/products/hw/ ... 42bc.shtmlBatman wrote:Someone shut off DHCP in the router. Result: I don't know the routers ip. Can't access the web interface using http or Cisco SDM. I can access IOS thru the console port but i am not proficient in IOS using the CLI.
If you need a Cisco cable, holler & I'll send one over. Clear the password (s)and at a console prompt: Show Run and post the results.