I have a CM300 that recently just started exhibiting a problem.
Upon power up, the screen shows "synthunl". I'm guessing this is a synthesizer out of lock issue.
1. Is this going to be a simple fix? AND
2. How much is this going to cost?
Thanks.
CM300 Problem - UPDATE
Moderator: Queue Moderator
CM300 Problem - UPDATE
Last edited by beemare on Fri May 18, 2007 4:41 am, edited 1 time in total.
-
HLA
- Posts: 2334
- Joined: Mon Jul 11, 2005 8:15 pm
- What radios do you own?: HT1550's, X9000's, CDM1550's
those radios havn't been out a real long time is it still under warranty? if so send it back.
HLA
I never check PM's so don't bother, just email me.
I won't reply to a hotmail, gmail, aol or any other generic free address, if you want me to reply use a real address.
STOP ASKING ME FOR SOFTWARE OR FIRMWARE, I JUST FORWARD ALL OF THE REQUESTS TO THE MODERATORS
I never check PM's so don't bother, just email me.
I won't reply to a hotmail, gmail, aol or any other generic free address, if you want me to reply use a real address.
STOP ASKING ME FOR SOFTWARE OR FIRMWARE, I JUST FORWARD ALL OF THE REQUESTS TO THE MODERATORS
CM300 Question - UPDATE
I just found out that the guy who has the radio, had his whip stolen by someone while the radio was on. If he didn't realize the whip was gone, and transmitted would that have caused the synth unlock issue?
I would figure there could be an issue with the PA if that happened, but would that have caused the synth to unlock?
I would figure there could be an issue with the PA if that happened, but would that have caused the synth to unlock?
