Page 1 of 1
How to reset the RCH3000
Posted: Wed May 23, 2007 7:40 pm
by MB
I had a power outage today and now my RCH3000 shows Fail 01/90 on the screen. It alternates from the screen that shows the firmware version to Fail 01/90 about every 10 seconds. Any idea on how I can reset the RCH300 or get this error to go away?
Posted: Wed May 23, 2007 8:00 pm
by 4n6inv
Reset the control station and make sure it boots up OK. Unplug the wall wart for the RCH3000; give it 15 seconds and plug it back in. That should do the trick. If not; you have problems, my friend...
Posted: Thu May 24, 2007 9:44 am
by wavetar
Also check to make sure your consolette isn't on some kind of breaker which didn't come on when the power was restored. FL 01/90 means the remote isn't communicating with the consolette.
Todd
Posted: Fri May 25, 2007 7:04 am
by MB
Fixed! After I reset the consolette and plugged the RCH3000 back in the system came up fine. Thanks for the help.