Batboard

I am getting the following error when attempting to write the the radio. "Type control block bit for Vector #39 is 1 but vector is 0" Then the following "The device is not supported by this application" I had not problems reading the radio before this. Now the radio says "eeprm cs error" on the display. Any help would be great. Thanks guys

open up an old saved codeplug and write it back to the radio and the error should go away.

OK I'll try it. The only problem I have is that it is a new radio to me and I dont have an old codeplug with this serial number. I made the stupid mistake of not saving it as soon as I read it. The model number of the radio is AAH25RDH9DP6AN. If anybody has an idea on a codeplug that will work, please let me know. Thanks again for the help.

OK...good news !!! Problem solved. The errors seemed to be while using the newest version on the CPS. When I switched to the older CPS version 6.04.00 there was no problem reading or writing codeplugs. Must be bugs in the newest version. Hope this helps somebody.