Batboard

Hello.
I'm sure this q has been asked before but.
I have a gp680 that i tried to flash into a 380 but in the middle of this the pc froze.
So basically i have a bricked 680.
Has anyone managed to revive their radio after this has happened?
I know that it's probably just going to be used as a paperweight, but any ideas would be really helpful.

run a search and you will find better directions but you will either have to send it in or use the method with a Y cable but that way you will need 2 radios.

Read the messages on my homepage.
I think,you don´t programmed the lab codeplug first.
Flash the radio with the gp6xx lab firmware and program the gp3xx lab codeplug.
After this flash the gp3xx lab firmware.

Andreas

I actually have a GP680, i swap the codeplug and firmware, for the firmware and codeplug for GP380

if the radio will not work,start the lab upgradetool and program the radio with the hardware codeplug only or ty to program hardware and application codeplug only (Phase3).

Andreas