Batboard

Hello All,
I recently had my HT1250 sent back to the factory for repair because the side outlet for a microphone was sensitive and sometimes would not work. Anyway, Motorola repaired it, putting a new case on the radio and covered it under warranty. I had a stored voice board in my radio before it left, now my buttons I had programmed for the stored voice board to operate it do not work. I tried going into the menu and then into the stored voice board and those functions (record) do not work. I tried reprogramming the radio with my codeplug and its still the same. Does anyone else have any suggestions before I call up my local M representative that sent it back to the factory for me?

Do the stored voice option boards have to be programmed separately? If so, how is that done? I didn't see anything about those on the CPS other than specifying what option board you have on the radio.

Thanks,
JC

look at the printout that came back from motorola, it will say on it along with what they did & what they fixed if there was anything extra sent in with the radio like battery, antennae, modules, charger and it would of been written down. no the board itself doesn't have to be programmed separately, you just plug it in and turn it on in the cps.

Thanks,
I'll have to look into that!!

JC