Batboard

I've been trying to figure out what I've been doing wrong in setting up a scan list on a Model 2 XTS3000 (CPS 04.01.02).

The scan list has three members. If I'm on channel 3, keying up on channel 1 or 2 will trigger the scan. If I'm on channel 1 or 2 and key up channel 3 the scan will not trigger, but the other two channels will show up on scan. All settings appear to be the same and the Rx/Tx/PL settings are correct.

Any ideas as to what I'm doing wrong? Has anyone else ever had an issue like this..?

Sounds weird, but...

Do you have the Autoscan turned OFF in each
conventional personality you're scanning? That's
where I would start looking anyway.

Tom in D.C. wrote: Do you have the Autoscan turned OFF in each
conventional personality you're scanning? That's
where I would start looking anyway.

It is now. I've tried it both ways...

I've also tried both dynamic and non-dynamic scan...