Page 1 of 1
XTS5000 programing needed
Posted: Wed Aug 22, 2007 8:53 am
by motofan44705
i have a XTS5000 that i need prog. if anyone can do it PLEASE let me know
it needs to be done with 9.90 or higher
i can can for shipping both ways
Re: XTS5000 programing needed
Posted: Wed Aug 22, 2007 2:54 pm
by HLA
i can do it for you but where are you located if somebody is closer?
Re: XTS5000 programing needed
Posted: Wed Aug 22, 2007 3:25 pm
by motofan44705
Email sent to your reply
Jim
Re: XTS5000 programing needed
Posted: Wed Aug 22, 2007 3:30 pm
by txshooter
motofan44705 wrote:Email sent to your reply
Jim
Where are you located, you may have a member fairly close to you that may be able to assist you. It sure would save you money and time on shipping.......
Also, you could most likely be there when it was done to head off any possible problems........
Re: XTS5000 programing needed
Posted: Wed Aug 22, 2007 3:34 pm
by motofan44705
Scott
I am in Northeast Ohio so my surrounding major cities are Cleveland, Ohio Canton, Ohio Youngstown, Ohio I'm only about 1 hour from PA like Monaca, Pittsburgh and so on. So say a 75 to 85 mile radius from Mahoning County Ohio would be good.
Jim
Re: XTS5000 programing needed
Posted: Wed Aug 22, 2007 3:37 pm
by motofan44705
Heck even a 2-3 hour drive would be ok it would cut out shipping time and cost wise with gas it would even out and like txshooter stated it would even eliminate possible error on programming.
Jim
Re: XTS5000 programing needed
Posted: Sun Aug 26, 2007 12:59 pm
by motofan44705
Thanks for all the offers guys got it taken care of by a fellow board member in my area.
Jim