Error 01/22 & No Prog Scan

[astrousa]

Running an xts5000 800 M3 Host R9.00.05 / DSP R9.00.02 on power up getting Error 01/22 & again within a second - does not flash on the radio after the 2 times.

Programmed scan list does not work - Picked Prog on the cps menu list, assigned a scan list # to the personality. Prog does not show as an option in the radio menu. So programmed the a/b/c switch to go into program while in b - it does but only lets me recall the scan list i inputted in cps - not allowing the sel or del button to work. Scan list has 5 members so its not full. Followed the CPS rules on prog scan. The radio scans the ch's i put into the list using cps. Have never seen this prob in a radio, always assign prog to the menu & it always works flawlessly.

Maybe the 01/22 is causing the prog scan not to work? Have heard a display with C01 works with certain band splits & vocon boards? Will take a few mins later & take it apart to be sure everything is making contact correctly.

Anyone have an idea?

[PhillyPhoto]

Not sure about the error, but as far as the scan list goes, try seeing if there's a setting for "Operator Select" under the options for that scan list. It should be under something called "List Members" or something similar. I'm not too familiar with the 5000's, but I know this is how it's setup in the 3000 CPS, and I'm sure scan lists are similar.

[The Pager Geek]

Tuning Codeplug Checksum Error

Try changing a value in Astro 25 tuner and save it. Hopefully by changing a value (and then change the value back again) the program will correct the errored checksum.

Otherwise, new RF board (since the tuning values are stored on the RF board.)

tpg

[astrousa]

Many thanks for the replies!! Operator select fixed the scan problem & the tuner aligned the board correcting the error! It powers up & passes self test now!