Page 1 of 1
RLN1015D Smart Rib question...
Posted: Sat Sep 15, 2007 8:04 am
by N4DES
Is the power supply for the RLN1015D SmartRib the same as a standard rib (RLN4008) and if not what is the the power requirements for the SmartRib?
Mark
Re: RLN1015D Smart Rib question...
Posted: Sat Sep 15, 2007 8:13 am
by fail999
The voltage and current requirements a virtually the same BUT good old mother /\/\ reversed the polarity of the connector. Center is ground, shell is positive.
fail999
Re: RLN1015D Smart Rib question...
Posted: Sat Sep 15, 2007 8:20 am
by N4DES
I think I found the answer...center is negative and 9v is required.
So now for another one, why the 3 position switch? What does the difference between -, 0, and XP?
Re: RLN1015D Smart Rib question...
Posted: Sat Sep 15, 2007 8:29 am
by fail999
Pretty sure this has been covered. Basically it switchs the internal uP frequency slightly to remove birdies that show up with some radios.
Re: RLN1015D Smart Rib question...
Posted: Sat Sep 15, 2007 12:42 pm
by N4DES
OK got it...thanks for the replies.