Page 1 of 1
Gr300 M120 How to convert to Repeater Mode
Posted: Sat Sep 15, 2007 10:15 am
by mirage
I Have a GR300 that someone here programmed the M120's as a standard radio. How do I get it to work back in the repeater mode. Right now it says it has to be a 16ch radio only.
Thanks for any help Doug
Re: Gr300 M120 How to convert to Repeater Mode
Posted: Sun Sep 16, 2007 3:15 pm
by Edgar
By default in m120 you find COR in Pin 8, on acc connector, need no special programming, if you dont have the pinouts
make one
TX RX
pin 2 pin 11 Audio
pin 3 pin 8 COR
pin 7 pin7 GRND
if you dont have RICK you can add from pin 8 to pin 7 one 15v 33uF, or 47 uF, depennding how much hang time need,
Re: Gr300 M120 How to convert to Repeater Mode
Posted: Sun Sep 16, 2007 4:15 pm
by mirage
Ok maybe I was not the clearest the radio will not program using the GR300 software as a repeater radio so I do not have to use a rick the program prompts me to have a 16 channel radio.
Doug
Re: Gr300 M120 How to convert to Repeater Mode
Posted: Sun Sep 16, 2007 5:56 pm
by HumHead
Please do not post the same topic in more than one forum.