Page 1 of 1
HT1250 error message !!!!! in cps
Posted: Mon Sep 17, 2007 5:54 pm
by dispatcher7586
Type control block bit for vector #28 is 0 but vector is **********
Unable to unpack (vector block and type control block not sync)
whats does this mean how is this fixed?
Re: HT1250 error message !!!!! in cps
Posted: Mon Sep 17, 2007 8:25 pm
by The Pager Geek
Let me guess, it has a EEPROM CS ERROR?
tpg
Re: HT1250 error message !!!!! in cps
Posted: Tue Sep 18, 2007 3:57 am
by dispatcher7586
No, he radio works perfectly. Just when I try to open the archive codeplug in the cps it has that message. But the radio is fine.
Re: HT1250 error message !!!!! in cps
Posted: Tue Sep 18, 2007 5:31 pm
by RKG
I'll bet your install of the CPS is corrupt.
Re: HT1250 error message !!!!! in cps
Posted: Wed Sep 19, 2007 8:06 am
by dispatcher7586
I believe the problem is that the radio that got programmed has a firm ware of 1.00 and it ran veryslow. The computer probally couldnt open it anymore. But the cps reads and write on other radio still, just not the old firmware on, but the old still operates Tx Rx.