Page 1 of 1
xts2500 signal indicator
Posted: Tue Sep 18, 2007 9:07 pm
by n3obl
Have a XTS2500 here that does not show the little bars with the signal strength on a trunk system. However another radio does.
The radio in question has ver 5 firmware. I assume this is old.
Frank
Re: xts2500 signal indicator
Posted: Wed Sep 19, 2007 7:00 am
by Mfire39
Old firmware, and the radio's trunking system has to be set to SMARTzone for the RSSI meter to work.
-Marc
Re: xts2500 signal indicator
Posted: Tue Sep 25, 2007 2:09 am
by DES-AJ
I've got a 2500I - Firmware 8 - RSSI works fine.
Get the firmware flashed up.
Re: xts2500 signal indicator
Posted: Thu Sep 27, 2007 3:04 pm
by WCHija
Does the xts5k have this option? if so where isi t?
Re: xts2500 signal indicator
Posted: Thu Sep 27, 2007 3:16 pm
by Monitor142
Yes, the XTS5000 does have it. It only works in a SmartZone environment from what I have seen. As someone else posted, it works at least on Host 8 and higher, maybe earlier. I do not believe that it works on conventional. If it does, please share !
Brian
Re: xts2500 signal indicator
Posted: Thu Sep 27, 2007 3:26 pm
by WCHija
where do i enable it?
Re: xts2500 signal indicator
Posted: Thu Sep 27, 2007 4:49 pm
by Mfire39
You don't have to "enable" it.. If you have a legit SmartZone trunking system in the radio, and it is set to "SmartZone", it will show up on the display..
-Marc
Re: xts2500 signal indicator
Posted: Thu Sep 27, 2007 4:50 pm
by n3obl
under trunking system..
Even with ver 5 firmware. i turned on smartzone and waited.
It appeared.
Frank