MTS2000 - MDC Display???

This forum is for discussions regarding all aspects of Motorola radio programming, including hardware, computers, installation and use of RSS/CPS, firmware upgrades, and troubleshooting. There are subforums for discussions of codeplugs, and also for software/firmware release notes and issues.

Moderator: Queue Moderator

Post Reply
Tim
Posts: 448
Joined: Wed Mar 20, 2002 4:00 pm

MTS2000 - MDC Display???

Post by Tim »

Hi all,

I have a VHF MTS2000 - SW rev # 05.53.

I cannot figure out how to make it display an MDC ID #!

On the specific personality, I have enalbed MDC System 1, enabled
alert decode, and on the radio wide display options, selected
ID only under 'caller ID'.

Any more places I should look?

Thanks,

Tim
Top
User avatar
Mfire39
Moderator
Posts: 1331
Joined: Sat Jan 17, 2004 8:53 am
What radios do you own?: APX

Re: MTS2000 - MDC Display???

Post by Mfire39 »

Get the firmware upgraded... I don't think MTS's started decoding ID's until somewhere after R06.xx something..

-Marc
Stupidity creates job security!

If your radio has old firmware, programming it with the latest CPS will not add any new features unless you have the latest firmware to match..

CPS = Customer Programming Software, Not CPS Software.
Top
Tim
Posts: 448
Joined: Wed Mar 20, 2002 4:00 pm

Re: MTS2000 - MDC Display???

Post by Tim »

Thanks Marc - I'll look around for someone who can
re-flash it.

Tim
Top
Post Reply

Return to “Radio Programming”