Page 1 of 1
Verifying DIU3000 encryption support
Posted: Fri Oct 26, 2007 2:43 pm
by Twisted_Pear
What's the process to check whether a DIU 3000 will support encryption either when it can't be powered or when it can be (by just AC to the rear).
Re: Verifying DIU3000 encryption support
Posted: Fri Oct 26, 2007 3:24 pm
by RFguy
1) Check to see if there is an encryption cartridge installed. If there is not one, then no encryption. There is a hole in the front of the DIU. If there is a cartridge installed, there will be a small 6-pin connector behind the hole plug. If no cartridge installed, there is just a void area behind the hole.
2) If a cartridge is installed, power up the unit and read with RSS. There is a screen that will display installed encryption options
Re: Verifying DIU3000 encryption support
Posted: Fri Oct 26, 2007 4:03 pm
by Twisted_Pear
Excellent info, thanks! Is the connector to keyload the board something commonly used by Moto or a one-off for the DIU?
Re: Verifying DIU3000 encryption support
Posted: Tue Oct 30, 2007 2:28 pm
by RFguy
It is a common cable. Same as for the ASTRO Spectra and consolette base.
It is a 6-pin Hirose circular connector.
My Motorola info shows the following detail:
Keyloading Cable for RNC, DIU 3000,ASTRO Spectra, XTL2500, XTL5000, MGEG, KMF.
Correct keyloading cable adaptor for ASTRO Spectra, XTL2500, XTL5000 must be ordered separately