Batboard

Quick question. LFL Liberty with cencom gold controller. Do you have to program the controller so that one of the buttons is used to change the flash pattern or does the light bar have a pattern change wire? both?

The pattern wire is located with the rest of the control wires in that same cable. You can either:

1-Sacrafic a button on the cencom and use the cencom to change the pattern
2-Install a momentary switch next to the Cencom (or any other place) to do the same thing
3-Place the bar in "action scan" and not worry about the extra wacker options available

Ok, can you tell me which wire it is?

http://www.whelen.com

On that site is a section for install guides for just about every product...all in pdf.