Page 1 of 1
Pac Rt Cdm1250
Posted: Sat Dec 01, 2007 7:34 am
by JCC419
I have a low band CDM1250 and was wondering if its possible to use a vhf pac rt with it and what would be needed
to do this
Re: Pac Rt Cdm1250
Posted: Sat Dec 01, 2007 2:33 pm
by libuff
yes it is possible, you need the correct connector, or some serious understanding of the 16 pin connector and the pin-outs of a pac-RT. however, you need to remember, that your PAC-RT and CDM1250 cannot be the same band, so VHF-LO and VHF-HI are ok... but VHF-HI and VHF-HI are NOT ok, although im sure it can be achieved.
we use VHF-High CDM's with UHF-T pyramid vehicle repeaters....
Re: Pac Rt Cdm1250
Posted: Sat Dec 01, 2007 11:26 pm
by Josh
libuff wrote:yes it is possible, you need the correct connector, or some serious understanding of the 16 pin connector and the pin-outs of a pac-RT. however, you need to remember, that your PAC-RT and CDM1250 cannot be the same band, so VHF-LO and VHF-HI are ok... but VHF-HI and VHF-HI are NOT ok, although im sure it can be achieved.
we use VHF-High CDM's with UHF-T pyramid vehicle repeaters....
You shouldn't have a problem interfacing it to the radio, I did it with mine with good results.
You'll have to use the CPS to program a pin for external PTT, and also be sure that the discriminator pin is not setup for filtered audio.
-Josh