Power on & hold Reset , on Minitor V

[Cory516]

Minitor V.
2 ch. , A is sel call , B is open line and vibe (dont ask why , I guess thats what you get when the Fleet Mgr. programs pagers) both F1. C is sel call and D is open and vibe both F 2.

Can anyone tell me whats going on here ? I was holding the reset button and turned the pager on while on channel A , then 1 short beep and red light comes on , hit reset again it goes to green , hit again goes back to red and so on... also the voice replay button does the same , switch from A to B same also (I know channel C and reset and power on is programming mode) but if I switch to D in this mode I get open line and open squelch from F1(thats right F1 ??)

Turn it off and on again all seems to go back to normal.

Anyone know what I am doing here , I sure dont , but it's fun

[ai4ui]

test/service modes

RG