Page 1 of 1
Saber's buttom assembly question
Posted: Sat Dec 22, 2007 9:53 am
by MotoFAN
Hi all!
May be I am dummy, but I am really have no ideas about where has been placed this small ruber:
By
MotoFAN
Please help!
Will be better, if you specify a place by an arrow
Re: Saber's buttom assembly question
Posted: Sat Dec 22, 2007 10:22 am
by Tom in D.C.
You should have two of those rubber grommets.
They go around each of the two threaded studs
that stick through the bottom of the base to sort
of seal the opening, that's all.
Re: Saber's buttom assembly question
Posted: Sat Dec 22, 2007 11:43 am
by mancow
They go INSIDE around the two threaded studs on the radio body.
Re: Saber's buttom assembly question
Posted: Sat Dec 22, 2007 12:22 pm
by MotoFAN
Tom in D.C.
mancow
Thank you guys!
All found and fixed!
Re: Saber's buttom assembly question
Posted: Tue May 07, 2013 4:53 am
by MotoFAN
Hi all!
Is the base plate (swown on above pic) of Astro Saber differs from regualar Saber?
Re: Saber's buttom assembly question
Posted: Tue May 07, 2013 12:25 pm
by Will
I think they are the same as the later Saber baseplate.
Re: Saber's buttom assembly question
Posted: Wed May 08, 2013 12:07 am
by MotoFAN
Will wrote:I think they are the same as the later Saber baseplate.
REX4422A (aka UHF SABER XMIT NOISE REDUC KIT) contains new baseplate?