Page 1 of 1
Changing a HT1250 from UHF to VHF
Posted: Thu Jan 03, 2008 8:04 am
by nick.dejohn
As the title says above, can it be done through HEX Editor???
Re: Changing a HT1250 from UHF to VHF
Posted: Thu Jan 03, 2008 8:13 am
by Grog
nick.dejohn wrote:As the title says above, can it be done through HEX Editor???
Don't you think there might be a few parts that need to be changed as well?
Re: Changing a HT1250 from UHF to VHF
Posted: Thu Jan 03, 2008 8:46 am
by HLA
i'm shure there is a way to force it to be any band but it won't work without alot of internal modification
Re: Changing a HT1250 from UHF to VHF
Posted: Thu Jan 03, 2008 9:01 am
by libuff
take off the case, remove all UHF electronics, replace with the electronics from a VHF radio, re-power... about the only way easily feasible to make the modification...
you would need to do some serious modifications...
Re: Changing a HT1250 from UHF to VHF
Posted: Thu Jan 03, 2008 11:52 am
by nick.dejohn
Forget that. I thought it would be easier to do than that.
Never mind!
Re: Changing a HT1250 from UHF to VHF
Posted: Thu Jan 03, 2008 12:42 pm
by Mfire39
Since the Pro series utilizes a uni-board, it would make life alot easier to just get a VHF board, or a whole differrent radio.. Can't just swap out the RF section and blow a plug in like you can with others...
-Marc