Page 1 of 1
GM300 PROGRAMMING GOOF UP HELP
Posted: Sat Jan 05, 2008 3:42 pm
by anautofix
I HAVE 2 GM300 UHF RADIOS...LOANED THEM OUT ...THEY WERE 16 CHANNEL RADIOS...THEY WERE REPROGRAMMED USING MAXLAB SOFTWARE AND WERE TURNED INTO 32 CHANNEL RADIOS....NOW THERE IS NO DISPLAY NO RX NO TX.... THEY CHANNEL INFO SHOWS THE 32 FREQS PROGRAMMED..... CAN I GET THE RADIO BACK TO 16CH??? HELP I HAVE 2 BRICKS :>(
[email protected]
Re: GM300 PROGRAMMING GOOF UP HELP
Posted: Sat Jan 05, 2008 4:48 pm
by kf4sqb
At a guess, try blanking and re-initializing it. The topic of how to do so has been covered on the board several times.
Re: GM300 PROGRAMMING GOOF UP HELP
Posted: Sat Jan 05, 2008 10:15 pm
by HLA
i'd make it reak simple and say the people that borrowed them just bought themselves some radios
Re: GM300 PROGRAMMING GOOF UP HELP
Posted: Sun Jan 06, 2008 1:51 am
by kf4sqb
HLA wrote:i'd make it reak simple and say the people that borrowed them just bought themselves some radios
He does have a good point there....
Re: GM300 PROGRAMMING GOOF UP HELP
Posted: Sun Jan 06, 2008 8:33 am
by wavetar
They can be restored, using the information in this thread:
http://batboard.batlabs.com/viewtopic.p ... lank+board
They will both require complete tuning as per the service manual.
Todd
Re: GM300 PROGRAMMING GOOF UP HELP
Posted: Sun Jan 06, 2008 7:12 pm
by Max-trac
GM300s can be made into maxtracs, did they change the firmware chip???
Read thru this to see if it was done correctly;
http://www.batlabs.com/gmmax.html