Batboard

Anyone ever have a cdm1250 low band that wouldn't power up ? I heard sometimes that this can happen and is caused by a bad eeprom

There may be an issue with an internal fuse on the board behind the control head ribbon cable connector. I had a CDM1550 that would not power up and originally I thought I bricked it somehow.

Below is a link to the posts I made on this

http://batboard.batlabs.com/viewtopic.p ... 01#p327546

This may or may not be the issue but I replaced the fuse f0401 which did the trick for me and the radio still works fine. Some just put a jumper across the pads as well which of course will work the same.

ignition sense?