Page 1 of 1
Building a repeater cable
Posted: Sun Jan 27, 2008 4:14 pm
by M1225
Im wanting to build a cross band repeater cable for a maxtrac 300 and a m1225. I found the schematic for the cable but have a few questions on programing the radios. That is how do I program the acc conector on the radios? I think the m1225 may already be set but Im not sure about the maxtrac. Any help is greatly apreciated!
Re: Building a repeater cable
Posted: Tue Jan 29, 2008 12:04 am
by M1225
Any takers? Here is the cable I am talking about
http://www.storm.ca/~nand/990/RICK/rptr.pdf
Re: Building a repeater cable
Posted: Tue Jan 29, 2008 5:38 am
by Doug
Everything looks pretty straight forward, the only pin that your really going to be concerned about is pin 8 and you'll want to set that for CSQ PL/DPL detect and have it set to go low on which ever radio your going to use as a receiver.
Doug
Re: Building a repeater cable
Posted: Tue Jan 29, 2008 12:34 pm
by M1225
I guess I should have specified before that its going to be bidirectional. So the cor will be CSQ PL/DPL detect in the rss? I take it will be going out as well? Thanks
Re: Building a repeater cable
Posted: Tue Jan 29, 2008 2:03 pm
by Doug
Yes you are correct,
Re: Building a repeater cable
Posted: Fri Feb 01, 2008 3:04 pm
by M1225
Is pin 8 the pin thats used for the COR on the motorola RICK?
Re: Building a repeater cable
Posted: Sat Feb 02, 2008 12:33 pm
by Doug
The rick gives you a couple options, pin 14 or 8 depending on your dip switch configuration
Re: Building a repeater cable
Posted: Sat Feb 02, 2008 1:01 pm
by M1225
Ok thanks for all the help!
Re: Building a repeater cable
Posted: Mon Feb 04, 2008 6:05 pm
by M1225
Seem to be having some trouble on the pinout of the 1225 The ground and PTT seem to be right but the external mic audio pin is showing 8 volts
Also RX audio is not present at pin 11