MT2000 Scanning Issue

[jdr30]

Hello all. Don't know if you can help me or not, but here is the issue I am having:

I have a MT2000 with a top display. I have it set up to scan 4 channels, each in bank A. I have my scan list programmed so that the selected channel is the primary. When scanning, and the primary channels keys up, my radio does not pick it up for about 2-3 seconds, so I miss the message. It does not happen all the time, so my assumtion is there is a timer off and the radio is not checking the priority channel, or taking too long to scan the channels.

The only time option I see is the amount of time the radio takes to begin scanning again after the last transmission. But this happens even when no one is talking. So can I increase the scan speed, so that it picks up transmissions quicker? I did not see any options in the CPS, but I do have MTSXLAB I can use as well if needed. I am using the DOS programming software.

Thanks