Page 1 of 1
MTS2000 not programming with CPS
Posted: Tue Feb 12, 2008 6:16 pm
by mrnevitt
I have a MTS 2000 that i can read fine with CPS (R02.02.00) but cannot get it to program. In CPS it says that it is verifying that the radio will accept the codeplug and then the radio just restarts. No new info in the radio. Below is what I am working with:
Radio:
model - H01KDH9PW1BN
firmware - 5.30
last programmed with RSS in June of 07 (before i purchased radio)
Any suggestions? Thanks in advance for your time and help.
mike
Re: MTS2000 not programming with CPS
Posted: Mon Feb 18, 2008 1:56 pm
by W6WAW
Sorry. I posted a response to the wrong message. I just deleted the content of this message.
Re: MTS2000 not programming with CPS
Posted: Mon Feb 18, 2008 1:59 pm
by n7maq
Re: MTS2000 not programming with CPS
Posted: Tue Feb 19, 2008 4:51 am
by wavetar
Basically, CPS doesn't work with pre-toolproof radios, give or take a minor firmware rev or so. Your 5.30 is too old, you'll need to use RSS.
Todd
Re: MTS2000 not programming with CPS
Posted: Wed Mar 05, 2008 10:47 pm
by motoXTS5k
I have to same version cps 02.02.00. I am trying to program a radio by reading one alike. I read the first one fine, but when I go to write to the other radio it stops me because the serial number is not the same. What am I doing wrong.
Re: MTS2000 not programming with CPS
Posted: Thu Mar 06, 2008 9:26 am
by tvsjr
motoXTS5k wrote:I have to same version cps 02.02.00. I am trying to program a radio by reading one alike. I read the first one fine, but when I go to write to the other radio it stops me because the serial number is not the same. What am I doing wrong.
You need to use Clone, not Program.