Batboard

I just recently obtained a ex600xls and in the process of programing the radio ran into some difficulties. I am currently using cps version 6.02.05. The rotary knob right now is set to Zone Selection (continuous) and I am not able to change the setting to anything else. I am trying to set it to Channel Selection (Continuous) however it will not change. The selection is there but i am unable to change it. I have checked all the other setting with no luck. I do have multiple zones set up so there is not any issued with that. The zone are set correctly with multiple channels in each zone. I just can figure it out. Anyone have any advise????

if you want to email me the codeplug i'll look at if for you?

I'm not sure when it was, but the ability to change the knob from zone to channel select came about with a specific version of software.