Page 1 of 1
Test frequencies in Spectra software
Posted: Thu Mar 20, 2008 4:26 pm
by RADIOMAN2002
I have looked in the MOFLAGS and Bit Banging areas, and I havn't found where the tune up frequencies are located. Does any body have an idea where in the MLM addresses they might be located?
Re: Test frequencies in Spectra software
Posted: Thu Mar 20, 2008 4:40 pm
by Tom in D.C.
If you find out how to do this please let us all know. I'm tired of my
GTX alignment setup on 900 mHz that defaults to a pretty useless frequency
of 895 mHz instead of the 902 or 927 channels that I use.
Not that the Spectra RSS is the same as the GTX but I'd bet the same
setup/principle is employed for the default test channel.
Re: Test frequencies in Spectra software
Posted: Thu Mar 20, 2008 5:00 pm
by jackhackett
There's a good chance that they're in the firmware, and you'd have to hack the EPROMs.
Re: Test frequencies in Spectra software
Posted: Thu Mar 20, 2008 5:15 pm
by Tom in D.C.
Jack,
That's sort of what I figured would have to be done. Ugh.
Regards,
Re: Test frequencies in Spectra software
Posted: Mon Mar 24, 2008 1:38 pm
by RADIOMAN2002
Thats what I figured too. For some strange reason my VHF radio is testing on 201 mhz and displaying 400 mhz frequencies. Granted this is a reflashed radio from standard VHF to type II trunking.
Re: Test frequencies in Spectra software
Posted: Tue Mar 25, 2008 6:59 am
by RADIOMAN2002
Well I guess today will be the only time I have to look at this for a while. I have found M copyright statement, so I do know where the beginning of the EE-prom is. Also my original software is gone, so i have to look at each address individually unlike my original that let you look at whole pages at a time. This is going to take some time. Too bad it doesn't have a hex dump.