Page 1 of 1
PR400 QC II encode
Posted: Sat Apr 05, 2008 11:33 am
by arlojanis
I programmed a PR400 for QC II encode and PL encode for paging thru a repeater. The repeater is a little slow to transmitt and the first tone is not being transmitted completely. Is there a delay that can be programmed to delay sending the QC tones?
Re: PR400 QC II encode
Posted: Sat Apr 05, 2008 4:12 pm
by HLA
you can lengthen the pre time
Re: PR400 QC II encode
Posted: Sat Apr 05, 2008 4:34 pm
by escomm
how can the pre-time be lengthened? there are no options in the QCII system tab to adjust pre-time like there is for MDC and DTMF signalling
Re: PR400 QC II encode
Posted: Sat Apr 05, 2008 6:47 pm
by HLA
ok i just opened up a codeplug and it don't look like you have any options for your situation. can you set the tones off one after another so the secoend time will set them off?
Re: PR400 QC II encode
Posted: Sat Apr 05, 2008 6:54 pm
by dbfd588
couldnt you add a second or howerver much is gettin cut off to the first tone so it would make up for it? or set a mdc pred id for that channel
Re: PR400 QC II encode
Posted: Sat Apr 05, 2008 8:28 pm
by HLA
you can't do two signalings, you can't make it do mdc then qc.