Batboard

gday all, i have hre a GR300 and im trying to get the setup/knockdown working properly via mdc1200 rapidcall so far when i call alert the RX radio with the correct code it flashes CA on the screen and starts to TX and doesnt stop until i reset the rick with the setup nutton.. when it should knockdown the Tx radio? is this correct? can anyone tell me where im going wrong? im thinking i might have some jumpers in the RICK set wrong maybe?
cheers all

all good people i could hear it trying to switch the voltage off via pin 10 but the radio was still staying on . cut the 801 fuse and bingo! :)working a treat.

thanks to those who read my post