Page 1 of 1
Public Safety Mic for HT1250 800mhz
Posted: Sun May 04, 2008 8:03 am
by westcom
I just purchased a Public Safety Mic for HT1250 for UHF, but I need it for 800mhz. Is there a way to convert this?
Re: Public Safety Mic for HT1250 800mhz
Posted: Sun May 04, 2008 8:56 am
by escomm
no, the 800MHz MTX8250 uses an SMA antenna connector
Re: Public Safety Mic for HT1250 800mhz
Posted: Sun May 04, 2008 7:08 pm
by HLA
ya, no can do there, the 800 range of antennaes have a pin in the center like all of the ht1000's did so even if you did the the correct adaptor to work with the radio to go to the bnc, you probablly won't find an antennae to go on the mic.