Batboard

I have the ability to dynamically regroup radios on a 7.x system. All of the 'older' XTS 3000 and ASTRO mobiles seem to retain the dynamic regroup talkgroup after a power cycle, however, the XTL 5000's do not. After an initial use of the DYN TG and then a power cycle, the 5000's just tone indicating a unprogrammed channel in the DYN channel slot. Anyone know why? Is this a CPS feature to enable? I couldn't find anything in the help files regarding this. I would prefer that the 5000's retain the DYN TG until commanded over the system to do something else.

Thanks,

Sam

In the radios that I have seen that have this feature enabled, its was a feature setup in CPS. As both CPS ver are fairly close these days, open up codeplugs for each line and check the programming.

Let me re-ask the question a differnt way. We have searched the cps/codeplug programming but are not seeing it. Does anyone know where specifically this item is located or is it just systemic to the XTL5000 that you'll loose the DYN TG?

I have not seen a FSB out on this, so I can't see this being a known/common problem. Its gotta be a codeplug or a system problem. If you want, send me the CP for an astro spectra and the xtl and I'll comb thru them.