Page 1 of 1
XTS2500I Programming problem.
Posted: Sat Jun 14, 2008 10:22 am
by KMB
I want to programme a XTS2500I, but I cannot ind the "PWR" in Display & Menu setting part.
Also there is no "Tx Low" in buttons setting?
Is it XTS2500I is different with XTS5000?
Help.......
Re: XTS2500I Programming problem.
Posted: Sat Jun 14, 2008 1:09 pm
by dxon2m
XTS2500, by design, does not have option for low power via menu.
Re: XTS2500I Programming problem.
Posted: Sat Jun 14, 2008 7:55 pm
by KMB
Thanks for your reply, dxon2m.
That means I have to set some channels for Low power and some for High power output?
Then it is not convenience as XTS5000.
Re: XTS2500I Programming problem.
Posted: Sun Jun 15, 2008 12:10 pm
by dxon2m
Correct, you can create two sets of identical channels, one high power and the other low power and put them side by side in the zone list. That's the way I find easiest to switch from HP to LP.
Re: XTS2500I Programming problem.
Posted: Sat Jun 21, 2008 2:10 pm
by MotoFAN
In my opinion it is the big lack of XTS2500....
Re: XTS2500I Programming problem.
Posted: Sat Jun 21, 2008 3:00 pm
by Hightower
MotoFAN wrote:In my opinion it is the big lack of XTS2500....
Ya, why would they leave out hi and low selectable? Dumb, makes no sence.