Batboard

I have never been able to find a squelch setting in the CDM1250 programming software and was wondering if I was just missing it.I am using the latest software 6.10.02.I was wondering if it was the same way as the old gm300s where you had to do it manually inside?

Using the CDM1250 as a base and it picks up alot of interf.
Any help in this matter would be great

Thanks

It's in the Global Tuner software

There is a squelch softpot for various tuning points in the tuner. However, that isn't going to make interference go away. Its just going to hide it if you crank it up enough.

Ok Thanks for the replies.

The radio just came back from the depo and they could not get any data off the old code plug so it came back blank and all the settings are off compared to before.Thanks again

I have Global tuner R02.12.00 I am unsure if that will work with the new CPS 06.10 both pro series ?

Does anyone know if that will work?

try it, the worst that will happen is it won't read the radio. i'm almost positive that the tuner is very forgiving with firmware versions.