Page 1 of 1
BPR40 Magone Radio Problem
Posted: Mon Jun 23, 2008 4:40 am
by johnny1225
I have a BPR40 VHF Radio. Freq. 151.1150 with a TPL of 186.2. My questions is that the TPL on the receiver side is not working, it is not blocking anything out. The tx TPL is working find, does anyone no where i should look on the board or what part it might be that is causing this problem. Thanks in advance
John
Re: BPR40 Magone Radio Problem
Posted: Mon Jun 23, 2008 10:38 am
by a_j_b
Did you verify it is programmed correctly?
Re: BPR40 Magone Radio Problem
Posted: Mon Jun 23, 2008 8:29 pm
by com501
Check your button programming, too. Might be you have the monitor enabled...
BPR40s are relatively new. You might check warranty and see if it is still covered, if so, if there is a board problem, send it to MexiRola. Its a $150 radio.
Re: BPR40 Magone Radio Problem
Posted: Sat Jun 28, 2008 4:51 pm
by vb105
In the Conventional Personality settings, verify your PL Option is set as TPL.
Re: BPR40 Magone Radio Problem
Posted: Mon Jun 30, 2008 4:24 pm
by wavetar
I don't have the software handy to step you through it, but look around for a field to set the mute rule to "and"...sounds like it's set to "or".
Todd