Batboard

Hi, can somebody please advise me if the 4 channel version of the GM350 can be programmed to give a squelch output (COR) signal on the 16 pin connector on the rear of the radio.

It has been sometime since I have worked with these radio's and I suspect only the 128ch version can do it.

Can somebody please confirm.

Thanks
Allan

It is not called "COS" in the RSS, look for receiver active, or RUS. Could also be called carrier + PL/DPL active.

Only the 128 channel model can do this (using software). It might be possible to tap off a signal from the squelch circuit.