Page 1 of 1
Error 80040154 NEW HT1250
Posted: Mon Jul 07, 2008 10:41 pm
by Javamaniac
I have a new HT1250, and when i go to read it with CPS R06.09.06, I get the error message:
80040154: Couldn't createInstance on device after getting UUID.
What do i do, and how do i get it to read? I want to be able to program this radio asap! please help!
Re: Error 80040154 NEW HT1250
Posted: Tue Jul 08, 2008 12:16 pm
by HLA
what's the model number of the radio? and is it a new new radio or just new to you?
Re: Error 80040154 NEW HT1250
Posted: Tue Jul 08, 2008 1:48 pm
by Javamaniac
AAH25SDF9AA5AN
the radio is brand new, never programmed yet.
Re: Error 80040154 NEW HT1250
Posted: Wed Jul 09, 2008 11:33 pm
by Javamaniac
Any ideas???
Re: Error 80040154 NEW HT1250
Posted: Thu Jul 10, 2008 9:47 am
by Al
You didn't tell us the firmware revision that's installed in the radio now....it should be on the white tag on the chassis along with and near the model number.
Without knowing your F/W revision, I'd guess that your CPS is too old to recognize the codeplug structure in your portable.
Re: Error 80040154 NEW HT1250
Posted: Thu Jul 10, 2008 11:18 am
by MotoFAN
Try latest CPS version. I am not sure that 6.10.02 is latest version, but it's from May 2, 2008.
Re: Error 80040154 NEW HT1250
Posted: Thu Jul 10, 2008 1:11 pm
by Javamaniac
the Ver. No. is R05.13.04
and i used R06.09.06 and it didnt work...
Re: Error 80040154 NEW HT1250
Posted: Fri Jul 11, 2008 6:44 am
by Al
According to the firmware release notes for R05.13.04, CPS version R06.09.06 or later must be used with it. So if you do, in fact, have R06.09.06 it should work. Corrupted CPS/bad installation on your PC is a possibility.
Re: Error 80040154 NEW HT1250
Posted: Sat Jul 12, 2008 5:12 pm
by HLA
ya, that should work, i'd try another computer. what's your setup, are you using known good cables and rib? have you tried reading another radio with the same setup?